Scene Double SDBX/SA2-1 User's Guide download pdf (Page 19)

Installation 17

Local Unit Installation

To install a Local Unit:

1. It is recommended that the PC and other devices are switched off before

connection.

2. Using the supplied CPU KVM cable(s), connect the keyboard, monitor(s)

and mouse connectors on the computer (or KVM switch) to the

corresponding connectors on the Local Unit as shown in Figure 4.

Ensure that you attach the keyboard and mouse connectors to the correct

ports. The keyboard connector is purple; the mouse connector is green.

If your PC does not have a PS/2 mouse port, an active serial converter will

be required - Model No: Mdapt (PS/2).

3. If you have a dual access system, connect the keyboard, mouse and monitor

for the local console to the appropriate ports on the Local Unit. The ports

may also be used to feed into a KVM switch.

4. If you have an audio and serial enabled system, connect the audio cables

between the computer and Local Unit as follows:

Computer Local Unit

Audio Out (green) Audio In

Audio In/Microphone (pink/blue) Audio Out

5. If appropriate, connect the supplied serial cable between the serial port on

the computer and the Local Unit.

6. Connect the CATx cables from the Remote Unit to the corresponding

INTERCONNECT ports (1&2) on the Local Unit.

7. Power up the PC.

The Local Unit normally takes power through the PCs keyboard port. In video

only applications, this connection is not used and so an external PSU is

required. Please contact Technical Support to obtain a suitable power supply.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 48 49

No comments

Scene Double SDBX/SA2-1 User's Guide Page 19