Scene Double SDBX/DA2 User's Guide download pdf (Page 17)

Installation 15

Remote Unit Installation

To install a Remote Unit:

1. Switch off all devices.

2. Connect your keyboard, monitor(s) and mouse to the Remote Unit as shown

in Figure 2.

These ports may also be attached to the CPU side of a KVM switch in order

to have a remote CPU. However, if you are attempting to use the extender

between cascaded KVM switches this may not work. Please contact Technical

Support to discuss your application.

3. If appropriate, connect audio equipment and serial devices. Connect the

audio cables as follows:

Remote Unit Audio Device

Audio Out Speakers

Audio In (MIC) Microphone

See Appendix E: Audio/Serial Ports: Operation & Multi-Port

Configuration, page 45 for further information.

4. Connect the Primary CATx cable to the INTERCONNECT (1) socket on

the front of the Remote Unit. If required, connect the Secondary CATx

cable to the INTERCONNECT (2) socket on the front of the Remote Unit

(see Figure 3).

5. Connect the 9V power supply to power the unit.

Only use the power supply originally supplied with this

equipment or a manufacturer approved replacement.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 53 54

No comments

Scene Double SDBX/DA2 User's Guide Page 17